John P.
28th October 2005 13:12 UTC

Test script without compiling?
I've always wanted to ask this but never got around to it:

I was wondering if it's possible to run the script through the same process that goes on in makeNSISW compiler, but without actually compiling the .exe file? Just get the report at the end, or get an error if something's wrong?

The reason I'd like that is that when I compile a script now, sure enough if there is an error in the script, the compile process will halt, BUT sometimes I'd just like to test the script itself, and if it turns out there's nothing wrong with the script, then the compiler will go on to compile the .exe (obviously!).

The problem there is that with some of my installers it can take more than ten minutes to compile, because of the time it takes to compress the files. And it's a pain to have to wait for that, when I really didn't want to compile it at this stage, I just wanted to see if there were any clear errors in the script.

So is there something I can do to just test the script for errors without compiling it into an .exe?

kichik
28th October 2005 13:14 UTC

You can wrap all File commands with !ifndef DEBUG and define DEBUG when you want just to test. It won't test compressing the files, but it'll compile much faster.

_trueparu#
28th October 2005 15:23 UTC

Or just add this to the end of the script.

!error "Only testing!"

John P.
28th October 2005 15:51 UTC

Ha! Great advice! :)

-I'll try that. :)

_trueparu_
28th October 2005 21:22 UTC

Better one.

!verbose 0
!error ""

"/X!verbose 0" "/X!error ''"