wacaveman
21st August 2007 22:46 UTC

Component page setting...
Is it possible to change the text of the component screen based upon the results of a custom screen that is just before it?

Thanks,

-Kevin

Red Wine
22nd August 2007 17:47 UTC

Knowing the control id and sending message with ${WM_SETTEXT}.
If the installer is multilanguage, you may want to prepare corresponding language strings.

wacaveman
22nd August 2007 18:06 UTC

I am not sure what you mean. Do you mean to get the control ID of the components screen? I tried using PageEx, but the functionality is so limited, I think I can't use it to change my screen. I don't think it allows any dynamic capabilities. One of the troubles I have is figuring out where to put the functionality.

And are there corresponding controls for ${WM_SETTEXT}, so that I can change the title and such?

Anyway, I looked over E1.19 BannerTrimPath, and can't figure out what the hell it is doing, but I assume that I need to do something similar.

Thanks for the reply,

-Kevin

Afrow UK
22nd August 2007 18:31 UTC

Look at GetDlgItem and SendMessage in the manual. You haven't really specified which specific text you want changing on the components page.

Stu

Red Wine
22nd August 2007 18:53 UTC

...and searching the forum is always good idea,

http://forums.winamp.com/showthread....hreadid=158231