nsisuser22
14th July 2010 15:38 UTC

newbie - RegDLL
Hi,

I'm trying to use RegDLL to register a COM DLL.
When I run the setup I see error:
Could not load: C:\Program Files\Test\test.dll

The DLL is copied successfully.
What code can I add to check this issue, and abort installation on failure ?
The documentation for RegDLL says:
The error flag is set if an error occurs (i.e. it can't load the DLL, initialize OLE, find the entry point, or the function returned anything other than ERROR_SUCCESS (=0)).

I've tried using IfErrors, but with no success.

Thanks for any help,
Si.

jiake
15th July 2010 07:41 UTC

Try to register your dll by regsvr32. If success, using ExecWait '"$SYSDIR\regsvr32.exe" /s "INSTDIR\test.dll"' instead。

nsisuser22
18th July 2010 16:45 UTC

Thanks ,
it worked.